Toro STX-26 Operator's Manual page 41

9. With the spark plug removed from the engine,
pour 2 tablespoons of engine oil into the
spark-plug hole.
10. Place a rag over the spark-plug hole to catch
any oil spray, then use the starter or recoil
handle to crank the engine and distribute the oil
inside the cylinder.
11. Install the spark plug, but do not install the wire
on the spark plug.
12. Charge the battery; refer to
(page 29).
13. Check and adjust the track tension; refer to
Checking and Adjusting the Track Tension (page
32).
14. Check and tighten all fasteners. Repair or
replace any part that is damaged.
15. Paint all scratched or bare metal surfaces with
paint available from your Authorized Service
Dealer.
16. Store the machine in a clean, dry garage or
storage area. Remove the key from the ignition
switch and keep it in a memorable place.
17. Cover the machine to protect it and keep it clean.
Charging the Battery
41