Removing An Expresscard; Power Budgeting - National Instruments PXI Series User Manual

Chapter 2 Installation and Configuration
To install an ExpressCard, complete the following steps.
1.
2.
If you encounter too much resistance, do not force the card. Check the card
orientation and try again.
The NI PXI-8115 will automatically recognize the ExpressCard and load
the appropriate driver(s). Third-party cards may require that you install
additional drivers. Contact your ExpressCard vendor for more information.

Removing an ExpressCard

To remove the ExpressCard module push in the module and then release to
eject the card. Slide the card out of the slot.
Caution To avoid data loss and other potential issues, stop communication with your
ExpressCard device before removing it from the NI PXI-8115. In Windows, use the Safely
Remove Hardware tool to safely stop the ExpressCard.

Power Budgeting

The NI PXI-8115 is a high power, high performance controller. It may be
necessary to perform power budgeting to ensure that the chassis can
adequately power all of the modules in the system. Refer to
KnowledgeBase 3K69SDQT, Performing a Power Budget on a
PXI System, for tips on budgeting power.
NI PXI-8115 User Manual
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Hold the card so the top side is facing left.
Insert the card until it is completely seated in its connector. The
connector has an automatic eject mechanism. If you insert the card
and it is ejected, simply re-insert the card until it is seated.
2-26 ni.com