National Instruments PXI Series User Manual page 36

4.
5.
Note When any IP or identification settings are changed, you will be prompted to reboot
the controller for the changes to take effect. Click Yes to automatically reboot the RT
target. You may also reboot the controller by right-clicking on the target name under
Remote Systems and selecting Reboot.
After rebooting the PXI controller it will appear in the Remote Systems
category with the assigned name.
6.
7.
8.
After installation of the software the controller will automatically reboot
and you will now be able to program it using LabVIEW Real-Time.
Refer to the RT Getting Started Guide available on your host computer for more
Note
information about setting up your RT target.
© National Instruments
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
(Optional) Enter a name for the RT target in the Name text box.
(Optional) Set the network configuration options of the RT target in the
IP Settings section and click the Apply button.
For information about configuring network settings, refer to the
Configuring Network Settings book, accessible by browsing to
MAX Remote Systems Help»LabVIEW Real-Time Target
Configuration»Configuring Network Settings from the Contents
tab of MAX Help.
Expand the PXI controller view in the Remote Systems branch and
select Software.
Click the Add/Remove Software button in the toolbar to launch the
LabVIEW Real-Time Software Wizard.
Install the LabVIEW Real-Time software and device drivers that you
require on the RT target. Refer to the NI Web site at
enter the Info Code for the latest information about supported
etspc
software.
2-19
Chapter 2 Installation and Configuration
ni.com/info
NI PXI-8115 User Manual
and