Tcp / Ip Command; At+Cipmode : Setting Transmission Mode - Wiznet WizFi360 At Instruction Set

3.2.3 TCP / IP command

3.2.3.1 AT+CIPMODE : Setting transmission mode

Command string
AT+CIPMODE=<mode>
<mode>: data transmission
Parameters
- 0: AT command transmission mode (factory default)
and
description
- 1: transparent transmission mode (single communication)
Return Values
\r\n
and
OK\r\n
descriptions
Predecessors no
Command: AT+CIPMODE=1\r\n
Examples Reply:\r\n
OK\r\n
Command string
AT+CIPMODE?
Return Values
+CIPMODE:<mode>\r\n
and
OK\r\n
descriptions
Command: AT+CIPMODE=1\r\n
Examples Reply: +CIPMODE:1\r\n
OK\r\n
Command Description:
- This setting is not saved to Flash, after the next reboot / power-invalid;
- In the transparent mode the data, and when WizFi360 as TCP Client.
If the TCP connection is disconnected, WizFi360 continually tries to reconnect; as a TCP Sever.
If the TCP connection is disconnected, WizFi360 reestablished listening, waiting for a client connection.
If +++ is input to exit the transmission, AT command can send from UART to WizFi360.
3.2.3.2 AT+SAVETRANSLINK : Stored data set to transparent mode Flash
a. Save the data transparent mode (TCP single link) to Flash
Command string
WizFi360 AT command
Function Description
Set the transmission mode
Function Description
Query the transmission
mode
Function Description