Maintenance; Troubleshooting - TdA ZK300DC Installation And User Manual

ZK300DC SWING GATE OPERATOR USER'S MANUAL

11. Maintenance

Regularly verify that the gate swings freely.

Make sure the hinges function perfectly.

Verify correct operation of the safety devices.

Keep operator clean at all times.


12. Troubleshooting

Symptoms
Motor runs, but gate
does not open or
close.
Gate does not open
far enough or does
not have the proper
opening angle.
The motor does not
run.
Remote control does
not work.
Table 3
Possible cause
1.The gate is obstructed.
2.The operator is released.
3.The gate is obstructed.
The gate operator
installed properly according to
Fig.4 in the gate geometry
section of this manual.
1.Power supply.
2.The fuse in the control box is
broken.
1. The indicator light
remote control does not light.
2. Remote control is broken.
3. The operating distance is
too far away.
16
Remedy
1. Remove obstructions.
2. Engage the operator.
3. remote the obstructions.
Either modify
installation to meet Fig.4 or
is not
adjust the size or replace
the installation brackets in
accordance with the gate
geometry section of this
manual.
1. Check the power.
2. Change the fuse.
1. Check the batteries in
of
your remote control.
2. Change
control.
3. Make sure the operating
range is less than 30m.
the
the remote
S0019