TdA ZK300DC Installation And User Manual page 9

ZK300DC SWING GATE OPERATOR USER'S MANUAL
Front parts of gate operator
Move the front part of gate operator up and down slowly, check the installation height

of the gate bracket, fit the gate bracket to the gate, and use a level meter to check
the flatness of the operator (See Fig.9). Tack weld the gate bracket on the gate,the
bracket installation should meet the specifications as shown in Fig.4.
Release the gate operator, open and close the gate manually, performing complete

opening and closing travel. Movement must be smooth.
If this is not the case, review bracket positioning and that its dimensions conform to

those listed in the specifications of this document.
After you have identified the desired position of the bracket, remove the gate

operator, fix or weld the gate bracket on the gate permanently. See Fig.9.
Mount the front part of gate operator on the bracket using the pin and nut supplied.

See Fig.8.
Fig.7
9