Important Safety Information; Additional Features - TdA ZK300DC Installation And User Manual

ZK300DC SWING GATE OPERATOR USER'S MANUAL

1. Important Safety Information

Please read these important safety instructions and follow all instructions as
incorrect installation can lead to severe injury/death or property damage:
DISCONNECT the power from the MAINS before making any repairs or removing its

covers. ONLY experienced service gate installer can install the gate and control unit.
Drive through the gate system only after complete opening.

DO NOT operate the gate operator unless the gates are in full view and free from

objects such as cars and children/people. SERIOUS PERSONAL INJURY and/or
property damage can result from failure to follow this warning.
The gate must be WELL BALANCED. Sticking or binding gate must be repaired by an

experienced service gate installer prior to Opener installation.
DO NOT allow control devices to be placed so that a person can access them by

reaching through the gate.
NEVER active your gate operator until you ensure that the area is clear of people,

pets or other obstructions.
When using the auto close mode, a PHOTOELECTRIC BEAM must be correctly fitted

and correctly tested for operation at regular intervals. EXTREME CAUTION is
recommended when using the Auto close mode. All the safety rules must be followed.
NEVER mount any device that operates the gate operator where the user can reach

over, under, around or through the gate to operate the controls.
We strongly recommend the use of PHOTOELECTRIC BEAM to provide ADDITIONAL

SAFETY PROTECTION.
Failure to comply with the instructions above may result in personal injury/death or
property damage. Our company does not accept responsibility for damage or injury
resulting from installing this operator.

2. Additional Features

One drive operator for single gate installation, and two drive operators for dual gate

installation.
Supports up to 40 remote control transmitters, (2 transmitters included in the

packing)
User programmable and user erasable remote codes.

Remote control hopping code technology prevents your remote code being accessible

to others.
For safety protection, ZK300DC will stop if it encounters an obstruction during closing

or opening.
Manual key release design for emergency purposes.

3