Electric Lock; Flashing Light; External Button Switch; Infrared Photocell - TdA ZK300DC Installation And User Manual

ZK300DC SWING GATE OPERATOR USER'S MANUAL
C om
C lose
C om
O pen
C om
S top
O pen/C lose/S top
P ow er +
Infrared input (N .C .)
P ow er -
A larm lam p
E lectric lock
Electric lock (DC24V)
Connect two wires of electric lock to port 'Electric lock'.
Flashing light (DC24V)
Attach two wires of flashing light to port 'Alarm lamp'.
Install the external button switch (Normally open)
The ZK300DC is equipped with an interface for an external button switch or keypad.
To install the keypad attach two wires of your keypad to the port 'Open/ Close/ Stop'.

The keypad will function in single channel mode.
For three-button switch installation, use the terminals for multi-channel mode. The

port 'Com' is the common port, the port 'Open' is used to open the gate, 'Close ' is
used to close the gate, and 'Stop' is used to stop the gate.
Infrared photocell (Normally close)
If the infrared beam is interrupted during closing, the gates will stop immediately.
Connect signal wire of infrared device to 'Infrared input' (see Fig.14).

Connect common wire (i.e. 'power supply –') of infrared device to 'Power -', connect

'power supply +' of infrared device to 'Power +.

Battery

Connect battery to 'BAT+' (red) and 'BAT-' (black). A fully charged standard battery still can
provide enough power for operating 10 cycles after power disruption.
Learn button
Jumper
Indicator light
Fig.14 Control board diagram
14
A C 24V
B A T +
B A T -