Specifications; Necessary Tools; Site Preparation - TdA ZK300DC Installation And User Manual

ZK300DC SWING GATE OPERATOR USER'S MANUAL
4. Specification
Power supply
Motor
Rated force
90  opening or closing
time (one gate)
Max. gate weight
Max. gate width
Working angle of gate
Limit switch
Ambient temperature
Battery

5. Necessary Tools

The following tools may be necessary to install the ZK300DC operator. You will need an
electric drill, hacksaw, screwdrivers, tape measure, multimeter, level, wire cutters and wire
stripper, a socket set, and possibly access to a welder if your installation cannot use the
supplied brackets. If the brackets included do not fit your gate because of the dimensions
of your gate, you may have to fabricate brackets for your application or notch a column in
order to obtain the necessary set back.

6. Site Preparation

Before commencing installation, check the following:
The gate moves freely by hand for the full length of open and close travel.

Check that the structure is sufficiently strong and rigid, the operator must operate on

a reinforced point on the gate and that its dimensions and weights conform to those
listed in the specifications of this document.
The gate should be mounted to the fence post and swinging freely, there should be

little resistance in the swing of the gate.
Make sure that the gate is plumb and level.

The fence posts must be mounted in concrete.

If you want to use electric lock, make sure the bottom of the gate is 45-50mm from

the ground. If the electric lock is not required, make sure the distance from the
bottom of the gate to the ground more than 20mm.
In order to protect the wires, between the gate operator and the control box,

armored cable, galvanized cable or PVC conduit must be set into the concrete when
it is poured. The diameter of the cable must be more than 20mm.
Wires within the cable shall be located or protected so that no damage can result

from contact with any rough or sharp part.
Table 2 Technical data
AC240V, 50Hz
9.8 feet (3 meters)
-15ºC~+50ºC
5
DC24V 50W
1000N
20 seconds
300kg
90 or 105
Encoder
3.5Ah, 24V