Polycom RealPresence Group Series Setup Sheet page 4

Install the display mount brackets on the display. For the LG display, position the display mounting bracket
using the sixth hole from the top with the top mounting hole on the display. The bottom hole on the display is
the seventh hole up from the bottom of the bracket.
For the Sampo display, position the third hole down from the top of the display bracket with the third hole
down from the top of the display. The bottom hole on the display lines up with the fifth hole up from the bottom
of the display bracket.
Install the supplied 1/4-20 x 3.5 inch socket head cap screws at the top of each display bracket. Leave the
screws adjusted up before mounting the display to the top rail.
Repeat with the second display.
With the assistance of another person, lift the display and position the display bracket hooks above the edge
of the upper horizontal display rail on the Media Center. Carefully lower the display onto the rail, ensuring the
hooks are fully engaged with the rail and that the outer most bracket is positioned within the safety tab on the
outer rail end (1). Repeat with the second display.
Adjust the leveler screws as needed to help eliminate any gap between the two displays when they are tightly
abutted (2).
Polycom RealPresence Group Series Media Center Setup Sheet
4