Polycom RealPresence Group Series Setup Sheet page 2

Install the lower display rail by aligning the holes in
the display rail with the holes in the vertical
supports. Attach with four M10 x 25 flanged socket
head cap screws. Do not fully tighten.
Attach an upper display rail extension to each end of the center top display rail using two M10 x 25 flanged
socket head cap screws per extension.
Polycom RealPresence Group Series Media Center Setup Sheet
Install a lower display rail extension to each side of
the lower display rail using two M8 x 20 button
head cap screws and two M8 hex nuts per side.
Ensure the edge of the rail extension is 3.97 inches
from the inner cut edge of the bottom display rail.
Tighten using the supplied M8 wrench.
2