Renesas TSI721-16GEBI Quick Start Manual
Renesas TSI721-16GEBI Quick Start Manual

Renesas TSI721-16GEBI Quick Start Manual

Pcie2 to s-rio2 evaluation platform

Advertisement

Quick Links

Titl
®
PCIe2 to S-RIO2 Evaluation
Platform Quick Start Guide
Formal Status
April 20, 2015

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TSI721-16GEBI and is the answer not in the manual?

Questions and answers

Summary of Contents for Renesas TSI721-16GEBI

  • Page 1 Titl ® PCIe2 to S-RIO2 Evaluation Platform Quick Start Guide Formal Status April 20, 2015...
  • Page 2: About This Document

    PCIe2 to S-RIO2 Evaluation Platform Quick Start Guide Kit Contents Part Number Components Description TSI721-16GEBI Evaluation Board • PCIe2 to S-RIO2 Evaluation Platform with Tsi721 and CPS-1432 • PCIe2 to S-RIO2 Evaluation Platform Quick Start Guide RapidFET JTAG - • RapidFET USB to JTAG/I2C Module...
  • Page 3 Out-of-the-box Configuration Requires Connection to Host PC The evaluation platform is configured to operate connected in a PCI Express slot. It will not work stand-alone unless the board configuration is changed. For more information about the stand-alone configuration, see the PCIe2 to S-RIO2 Evaluation Platform User Manual.
  • Page 4 LED D1 Indicates the link between the host PC and Tsi721 is active. Connecting AMCs Insert AMC modules into the card guide assembly component-side-down. Push the module in the AMC connector gently until the module snaps in the connector. The evaluation platform uses a Hot Swap controller to control current flow to the AMC module. Current will be applied to the module only when the Presence Detect pins (PS0 and PS1) of the module make contact.The fans will turn, a green LED (D3) will indicate power has been applied to the modules, and the AMC ENABLE signal will be asserted.
  • Page 5: Serial Eeprom

    Connecting the JTAG Debugger (RapidFET) to Tsi721 There are two options: 1. Use the RapidFET pod and connect the connector labeled JTAG to the header labeled “BR JTAG”. 2. Connect the USB cable directly to the mini USB connector on the faceplate and launch the RapidFET software. Connecting the JTAG Debugger (RapidFET) to CPS-1432 Use the RapidFET pod and connect the connector label JTAG in the to header labeled “SW JTAG”.
  • Page 6: Contact Information

    Koto-ku, Tokyo 135-0061, Japan www.renesas.com/contact/ www.renesas.com Trademarks Renesas and the Renesas logo are trademarks of Renesas Electronics Corporation. All trademarks and registered trademarks are the property of their respective owners.

Table of Contents