Table of Contents
Advertisement
5
Wire the Zone Terminals
Terminals 8 through 12 connect grounded zones 1 through 3. Zones 2 and 3 can
also be used for access control with zone 2 providing a bypass feature and
zone 3 providing request to exit functionality.
Use the supplied 311 1K Ohm End‑of‑Line (EOL) resistors on each zone. Refer to the
panel programming guide for programming instructions. See Table 1 and Figure 8 for
more information on wiring the zone terminals.
Digital Monitoring Products, Inc.
|
734B Installation and Programming Guide
9
Advertisement
Table of Contents
Need help?
Do you have a question about the 734B and is the answer not in the manual?