Home The 994-X; How To Power Down The 994-X - Kval 994-X Operation And Service Manual

Powering Operations for the 994-X

Home the 994-X

The 994-X must go through a homing routine before any operations are performed. The homing
routine sets a zero reference from which the 994-X measures its movement and cutting process.
If power is lost or the 994-X is re-set, the homing routine must be performed again to reset the
zero reference.
Press the button on the
Home
The machine will move to the home position at the
1.
in-feed end of the machine.
The machine will then move to about the middle
2.
of its travel.
The 994-X is now ready for work.

How to Power Down the 994-X

Select
1. Shut Down System
operator interface program and shut down the operating
system.
Note: Make sure Windows is shutdown completely before
turning off the machine. Hard drive or data may be
damaged if not turned off in this order.
Switch the green
2.
OFF position.
KVAL also recommends that you turn the disconnect
3.
switch on the electrical cabinet to OFF; this helps reduce
possible damage resulting from power surges from electri-
cal storms.
touch screen.
Main Screen
from the
Main Screen
CONTROL TRANSFORMER
KVAL 994-X Operation/Service Manual
2-34
to close
1
2
switch to the
3