Data Harvest EASYSENSE Q3+ User Manual page 35

EASYSENSE Q3+ and Q5+
17. To prevent the Incoming COM port being shown
in the Interface connection's drop-down menu,
select the COM Ports tab (H), the Incoming COM
port entry (I) and click on Remove (J).
18. Press the red button on EASYSENSE Q three
times to return to the Main menu.
Step 3: Establishing communication
1. Open the EASYSENSE software program.
2. If this is the first time the EASYSENSE program has been opened a 'Select program
level' window will open. Select a suitable user's level i.e. Level 1 (up to 9 years old),
Level 2 (9 – 15 years old) or Level 3 (15 years plus).
3. If this is the first time the EASYSENSE program has been opened an interface
window will open. If this is not the first time and a communication error message
appears, click on Interface.
4. Select the Interface as EASYSENSE Range (K).
5. Select Serial port
outgoing serial (COM) port link from the drop-
down list (M).
6. Click on OK. The program will save your
selection so it will be automatically configured
when next used.
7. When a connection is established the Home window will open. Select one of the
experiment modes i.e. EasyLog, Graph, Meters, Scope, Snapshot or Timing.
Use after the initial set up
If the LCD display on EASYSENSE Q is turned off, press any button to wake it up.
•
If the blue LED doesn't start to flash check that Bluetooth is On (System menu ►
Bluetooth ► Bluetooth On/Off).
Note: Do not select 'Pair Bluetooth' – this action will delete any existing pairing and you will have
to complete the Bluetooth pairing process again.
Open the EASYSENSE software. As long as the EASYSENSE Q logger is being used
•
with the same computer (Bluetooth USB adapter, connected to the same USB port),
communication will be established and the Home window will open.
If EASYSENSE Q is operating on battery power with Bluetooth on and is not being used,
(e.g. not logging data, no buttons being pressed), it will automatically switch itself off
after nine minutes (LCD display blank). If EASYSENSE Q is off, Bluetooth
communication will cease and connection to the EASYSENSE software will be lost.
Press any button to wake up the logger before re-establishing connection. (If
EASYSENSE Q is connected to its mains power supply it will stay 'awake' at all times).
© Data Harvest Group Ltd.
(L) and then the Bluetooth
(I)
(K)
(L)
(M)
35
DO185 (2)
(H)
(J)