Fitting the thermal insulation and casing
Back panels
7.
Fig. 19
1. Secure the right and left-hand retaining rails to the
top and bottom fixing rails using 2 screws
each.
2. Hook the bottom back panel into the retaining rails.
3. Hook the centre back panel into the retaining rails.
4. Hook the top back panel into the retaining rails.
1.
5.
6.
4.
3.
qE
(cont.)
5. Align the back panels.
for
Check whether the seal of the control unit module
fits closely all the way round the top back panel. If
not, correct the position of the control unit module
using the 4 screws in the slots.
6. Refit the top back panel.
7. Screw in location stud
2.
.
3
25