Fitting The Side And Back Panels - Viessmann Vitocrossal 100 Installation Instructions For Contractors

Fitting the side and back panels

4.
2x
5.
Fig. 20
1. Insert M 6 x 10 screws. Hook the rails into place.
Tighten the screws.
2. Position the bottom of the side panels in the rails.
Hook the top of the side panels into the top rails on
the boiler.
If the gas line is to be routed along the side, break
out the perforated section in the side panel using
pliers.
3. Hook the back panel into the side panels.
If the gas line is to be routed to the back, break out
the relevant perforated section using pliers.
Loosely secure side panels with screws M6 x 10.
20
6.
3.
2.
1.
4. Hook the top back panel into the side panels.
5. Click the edge protectors into place.
6. Affix the type plate to the left or right side panel.