Table of Contents
Advertisement
C
Programming
C3
Deleting the Transmitter
In delete mode, individual transmitters can be de-
leted from the memory of an output.
Start program-
ming mode
M
Start delete
mode
P
Tx
5
Send transmission code
C4
RESET
A reset must be performed individually for each
output.
All programmed transmitters are deleted and all
switching times for the respective output are re-
set.
6
Operation
[ P r e s s b u t t o n ]
P
P
Select operating
mode L
M repeatedly
Select output
1/2/3/4
1/2/3/4
P until
(> 1.6 s)
Transmitter button
Tx 1x briefly
1)
If no buttons are pressed within 30 seconds, the RCR02 automatically switches back to operating mode.
The settings are not saved.
If a transmitter is programmed in several outputs, it must be deleted individually from each
output as necessary.
If an attempt is made to delete a transmitter that is not programmed into the selected output,
the LEDS flash quickly and the receiver remains in delete mode.
Operation
[ P r e s s b u t t o n ]
P
P
M repeatedly
1/2/3/4
P until
(> 1,6 s)
P until
(> 1,6 s)
1)
If no buttons are pressed within 30 seconds, the RCR02 automatically switches back to operating mode.
The settings are not saved.
1)
Display
1x briefly or
LED 2TB flashes
2x briefly
LED 1TB flashes
LED 1/2/3/4 and
LED xTB flash
LED output and 2TB
and 1TB flash quickly
LED output and 2TB
and 1TB light up
1)
Display
1x briefly or
LED 2TB flashes
2x briefly
LED 1TB flashes
LED 1/2/3/4 and
LED xTB flash
LED output and 2TB
and 1TB flash quickly
LED output ans 2TB
and 1TB light up
Note
Programming mode started.
Select delete function L.
Select output. Only one output can be
selected. Output can be changed as often as
required.
Delete mode started.
Cancel 1x P <1.6 s
Transmitter deleted from the selected output.
When all the LEDS go out, the receiver is
ready for operation.
Note
Programming mode started.
Select delete function L.
Select output.
Only one output can be selected. Output can
be changed as often as required.
Delete mode started.
Cancel 1x P <1.6 s
All transmission codes from the selected
output are deleted and the TIMER is reset.
When all the LEDS go out, the receiver is
ready for operation.
Advertisement
Table of Contents
