Standby Mode - Parkside PLSD 48 A1 Translation Of The Original Instructions

Standby mode

If the soldering iron is not used for 30 minutes, the soldering station
will go into standby mode .
■ In the standby mode, the LC display
200°C . At the same time, full-screen flashes on the LC display
♦ Press any optional button to end the standby mode and set the
desired temperature as described below .
Switching off:
NOTE
► After use, always put the soldering iron
for the soldering iron
♦ Move the ON/OFF switch
the plug from the socket when not in use .
│ GB │ IE │ NI
■ 8
shows a temperature of
.
to position "0" . Always remove
back into the holder
PLSD 48 A1
.