BMW C 400 X Rider's Manual page 74

ASC calibration has been com-
4
pleted.
The trip can be resumed.
72
Calibrating ASC
with Connectivity
Requirement
Lower stability reserves of the
ASC control after a tire change.
NOTICE
z
Calibration means that the con-
trol is adapted to the effective
tire radii of the front and rear
wheels.
The effective tire radii depend on
the tire brand, tread depth, tire
pressure and payload.
Every time the tires are changed,
calibrate the ASC control to
adapt it to the new tire radii.
As tire wear progresses, calibrate
the ASC control regularly to keep
it functioning optimally.
Before calibration, the
ignition must have been
switched off for at least
1 minute.
with Connectivity
OE
Switch on ASC (
ASC is activated.
Call up Start ASC
calibration and start the
calibration.
The calibration has been
started and waits for the
Scooter to be operated.
ASC indicator and warning
light begins to light up.
https://www.motorcycle-manual.com/
The menu item can only be
exited if the ignition is switched
off and on again.
ATTENTION
OE
70).
ASC is not available until
calibration is completed
Accident hazard
Carry out calibration on a flat
and straight stretch of road that
has good adhesion.
Ride straight ahead and remain
in the following speed range for
6 seconds, keeping your speed
as constant as possible.
The Scooter must be ridden
straight ahead within a certain
speed range:
19...31 mph (30...50 km/h)
ASC is calibrated.
Speed range for ASC
calibration