Advertisement
DASH DISASSEMBLY
1. Unclip and remove the dash panel
surrounding the radio. (Figure A)
2. Unclip and remove the radio trim.
(Figure B)
3. Remove (2) 9/32" screws securing
the radio, then pull down and back to
release the radio. Unplug the connectors
to remove the radio. (Figure C)
4. Unclip and slide off the plastic trim piece
on the top of the radio. (Figure D)
5. Remove (2) 9/32" screws securing each a/c
vent, then unclip and remove the vents.
Continue to Kit Preparation
(Figure A)
2
(Figure B)
(Figure C)
(Figure D)
KIT PREPARATION
Attention! After the sub-dash has been cut,
the factory radio will no longer be able to
be installed.
1. Cut the sub-dash to allow room for the
aftermarket radio. (Figure A)
2. Attach (4) panel clips provided with the
kit onto the radio trim panel. (Figure B)
Continue to Kit Assembly
Remove
shaded areas
(Figure A)
"Head On" View
(Figure B)
|
1.800.221.0932
MetraOnline.com
Advertisement
