Advertisement
Quick Links
INSTALLATION INSTRUCTIONS FOR PART 95-3527
APPLICATIONS
Pontiac Grand Prix
2004-2007
95-3527
KIT FEATURES
• Double DIN Radio Provision
• Stacked ISO Units Provision
KIT COMPONENTS
• A) Radio Housing • B) Double DIN Brackets • C) Double DIN Trim Plate
A
B
C
TOOLS REQUIRED:
Phillips Screwdriver • Panel Removal Tool
• Socket Set
1-800-221-0932
www.metraonline.com
© COPYRIGHT 2004-07 METRA ELECTRONICS CORPORATION
Advertisement
Related Manuals for Metra Electronics 95-3527
Summary of Contents for Metra Electronics 95-3527
- Page 1 INSTALLATION INSTRUCTIONS FOR PART 95-3527 APPLICATIONS Pontiac Grand Prix 2004-2007 95-3527 KIT FEATURES • Double DIN Radio Provision • Stacked ISO Units Provision KIT COMPONENTS • A) Radio Housing • B) Double DIN Brackets • C) Double DIN Trim Plate TOOLS REQUIRED: Phillips Screwdriver •...
- Page 2 95-3527 T ABLE OF CONTENTS Dash Disassembly - Pontiac Grand Prix 2004-07 ........1 Kit Assembly - Double DIN Radio Provision .
-
Page 3: Pontiac Grand Prix 2004-07
95-3527 DASH DISASSEMBL Y PONTIAC GRAND PRIX 2004-07 isconnect the negative battery ter- minal to prevent an accidental short circuit. Remove trim ring around key cylinder. (Figure A) Unclip and remove entire panel sur- rounding radio including message center and vents. (Figure B) To remove radio start at bottom of stack and remove (8) 9/32”... -
Page 4: Double Din Radio Provision
95-3527 KIT ASSEMBL Y DOUBLE DIN RADIO PROVISION Note: Refer also to the instructions included with the aftermarket radio. Snap the Double DIN brackets to the inside edge of the radio housing. (Figure A) Slide the Double DIN radio into the... -
Page 5: Stacked Iso Units Provision
95-3527 KIT ASSEMBL Y STACKED ISO UNITS PROVISION Note: Refer also to the instructions included with the aftermarket radio. Snap the Double DIN brackets to the inside edge of the radio housing. (Figure A) Slide the stacked ISO units into the... -
Page 6: Final Assembly
95-3527 FINAL ASSEMBL Y FINAL ASSEMBL Y (A) Strip wire ends back 1/2" B) Twist ends together C) Solder D) Tape Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individ- ually tape off the ends of any unused wires to prevent electrical short circuit.) - Page 7 95-3527 NOTES...
- Page 8 95-3527 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV. 06/19/07 © COPYRIGHT 2004-07 METRA ELECTRONICS CORPORATION INST95-3527...