Ricoh SP 230DNw Service Manual page 51

 Error code 9202
When printing from the paper tray, paper type setting in the machine does not match the
setting in the driver.
<User Check>
• Use the same paper type setting for the machine and driver.
Step
1 Malfunction of the main PCB
2 Main PCB failure
 Error code 9302
When paper was fed from the paper tray, the T1 paper feed sensor detected that no paper
was in the paper tray.
<User Check>
• Set paper in the paper tray.
Step
Connection failure of the T1
1
paper feed sensor harness
Connection failure of the T1
2
clutch harness
Connection failure of the paper
3
feed motor flat cable
T1 paper feed actuator caught in
4
some sections of the machine
5 Abrasion of the PF kit 1
Paper feed motor flat cable
6
failure
7 T1 clutch failure
T1 paper feed sensor PCB
8
failure
9 Paper feed motor failure
Damaged gears in the paper
10
feed drive system
11 Main PCB failure
Cause
Cause
2-37
Remedy
Install the latest main firmware.
Replace the main PCB ASSY.
Remedy
Reconnect the T1 paper feed sensor
harness.
Reconnect the T1 clutch harness.
Reconnect the paper feed motor flat
cable.
Reattach the T1 paper feed actuator.
Replace the PF kit 1.
Replace the paper feed motor flat cable.
Replace the T1 clutch.
Replace the T1 paper feed sensor PCB
ASSY.
Replace the paper feed motor.
Replace the frame L unit.
Replace the main PCB ASSY.
Confidential