Troubleshooting For Other Problems; Cannot Make Print - Ricoh SP 230DNw Service Manual

4.11 Troubleshooting for Other Problems

4.11.1 Cannot make print

<User Check>
• Turn the power switch OFF and then back ON again.
• Check that the USB cable is connected to the host correctly.
• Check that the LAN cable is connected to the host correctly.
• Replace the USB cable.
• Replace the LAN cable.
• Check that the maximum printable page number has not been exceeded.
• Check that the PC Print is not forbidden.
• Check the print limit ID.
• Check the network connection.
• Check the relevant section in the Network Setting Guide.
• Check that the print data is not damaged.
• Install the latest main firmware.
• Match the document size with the one specified in the driver.
Step
1
2
3
4
5
6
7
Cause
Connection failure of the
wireless LAN connector
Connection failure of the T1
paper feed sensor harness
Connection failure of the T1
clutch harness
T1 paper feed actuator
caught in some sections of
the machine
T1 paper feed sensor PCB
failure
Wireless LAN PCB failure
Main PCB failure
Reconnect the wireless LAN connector.
Reconnect the T1 paper feed sensor
harness.
Reconnect the T1 clutch harness.
Reattach the T1 paper feed actuator.
Replace the T1 paper feed sensor PCB
ASSY.
Replace the wireless LAN PCB.
Replace the main PCB ASSY.
2-68
Remedy
Confidential