Print Frame Pattern (Single-Side Printing) (Function Code 69) - Ricoh SP 230DNw Service Manual

1.3.11 Print frame pattern (single-side printing) (Function code 69)

<Function>
This function is used to print the frame pattern on a single side of the paper to check for
printing flaws and omission.
<Operating Procedure>
(1) Set the paper specified in the default paper settings (A4 or Letter) to the paper tray.
(2) Press the [▲] or [▼] in the initial state of maintenance mode to display "MAINTENANCE
69" on the LCD, and press the [OK]. "PRINTING" is displayed on the LCD, and the frame
pattern (refer to the figure below) is printed on a single side of the paper.
(3) When printing is completed, "WAKU SX" is displayed on the LCD.
When you press and hold the [Go] for five seconds, this operation is finished and the
machine returns to the initial state of maintenance mode.
Note:
• If printing fails, printing is stopped with displaying any of the errors shown in the table
below. To retry printing, refer to the "Remedy" in the table below to eliminate the error
cause, and press the [Go]. "PRINTING" is displayed on the LCD, and the frame pattern
is printed on a single sheet of paper.
Error display
Replace Toner
Cover is Open
No Paper
Jam Tray1
Jam Rear

Frame pattern
Replace the toner cartridge and press the [Go] to release the
error.
Close the front cover.
Refill the paper tray and close it. And then press the [Go] to
release the error.
Remove the jammed paper, close the paper tray and all covers,
and press the [Go] to release the error.
Fig. 5-6
5-21
Remedy
Confidential