Installing The Detector Base - Siemens FDL241-9 Mounting, Commissioning

Linear smoke detector

Hide thumbs Also See for FDL241-9:

Table of Contents

Mounting / Installation

Installing the detector base

3.2 Installing the detector base

12 | 44

Figure 9: Connection diagram for the source of DC voltage

WARNING

Danger of falling

Bodily injury

●

When installing, use a secured ladder or work platform.

CAUTION

Using the device in a damp and/or corrosive environment

Device function is impaired.

●

Use the M20 x 1.5 metal cable gland in damp and/or corrosive environments.

Figure 10: Mounting and electrical connection

1 Detector base

1. Break open the plastic parts in the detector base (1) at the openings you

require for cable entry. Note the arrows in the detector base indicating which

side should be at the top.

2. If necessary screw the M20 x 1.5 metal cable gland into the openings.

3. Install the detector base on a stable, vibration-free surface with two screws.

2 Carrier for connection terminals

A6V10332811_e_en_--

Table of Contents