Water Clock; Inserting The Batteries; Setting The Capacity; Displaying The Remaining Capacity - EauVation Acqua 80 Service Instructions Manual

Water clock

12 Water clock

12.1 Inserting the batteries

 Open the battery compartment (1).
 Insert two batteries (type AAA). Pay attention to correct polarity of the batteries.
 Close the battery compartment (1).

12.2 Setting the capacity

 Press and hold down button (2).
 Press button (3) with a ballpoint pen tip.
 Release both buttons as soon as "FLI1" flashes in the display.
 Press button (2) repeatedly until 8000 litres is shown on the display.
 Press button (3) with a ballpoint pen tip to store the value.
 "FLI 2" flashes. Shortly thereafter "OFF".
 Press button (3) with a ballpoint pen tip to turn off "FLI 2".
 Proceed the same way for "FLI3" to "FLI5".
As soon as the set water volume is exceeded, an acoustic signal is triggered.
 Confirm with button (3) to reset the alarm.
 Replace the hygiene filter.

12.3 Displaying the remaining capacity

 Press button (2).
 The remaining water volume is displayed.
 Press button (2) again.
 "FLI 1" flashes twice.
 The remaining capacity is displayed.

12.4 Reset

After replacing the hygiene filter, the consumed amount of water must be reset.
 Press and hold down button (3) for 8 seconds.
 An acoustic signal sounds.
 The consumed water is reset.

12.5 Changing the batteries

Weakening batteries are indicated by an acoustic signal.
 Open the battery compartment (1).
 Insert two batteries (type AAA). Pay attention to correct polarity of the batteries.
 Close the battery compartment (1).
20