Procedure - Delta Electronics HMC Series Manual

HMC Take-out Robot for Injection Molding Machine
(b) Detect time: When the system does not receive the signal within the setting time,
an alarm will occur. When the detection time is not set to 0, a window of time
delay will pop up and an alarm will occur.
To open and close the safety door again will clear the alarm and resume the
operation. Press [Alarm Confirm] ([F10]) to stop the operation.

3.5.3 Procedure

 Starts: Apart from the first cycle, each cycle starts from this command when it is in
auto operation. Commands before [Starts] will be regarded as the initial commands
for auto operation.
End: When executing this command, the cycle is over.

June, 2015
73