Speed Settings; High Speed Cutters; Engraving Cutters; Diamond Wheel Points - Dremel PawControl 7760-PGK Operating/Safety Instructions Manual

1600A01P55.qxp_7760-PGK 4/15/19 9:56 AM Page 33
Note: Each number settings listed in the speed charts = x 1,000 RPM
* Speed for light cuts, Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Note that the recommended speed may not be suitable for your rotary tool model.
Catalog
Number
100, 121, 131
114, 124, 134, 144 25-35
118, 190, 191, 192,
193, 194
116, 117, 125, 196 25-35
115
198, 199
Catalog
Number
105, 108
106, 107, 109, 110 25-35
111
112, 113
Catalog
Number
7103, 7105, 7117,
7120, 7122, 7123,
7134, 7144
Catalog
Number
9931, 9932, 9933,
9934, 9935, 9936

Speed Settings

High Speed Cutters

Soft Hard Laminates
Wood Wood /Plastics
25-35 25-35 12-17
12-17 9-11
25-35 25-35 9-11
12-17 9-11
25-35 25-35 9-11
25-35 18-24 9-11

Engraving Cutters

Soft Hard Laminates
Wood Wood /Plastics
25-35 25-35 18-24
25-35 12-17
25-35* 25-35* 18-24*
25-35* 25-35* 12-17*

Diamond Wheel Points

Soft Hard Laminates
Wood Wood /Plastics
25-35 18-24 -
Structured Tooth Tungsten Carbide Cutters
Soft Hard Laminates
Wood Wood /Plastics
25-35 18-24 9-11
Aluminum,
Steel
Brass, etc.
12-17 18-24
12-17 12-17
12-17 25-35
12-17 12-17
12-17 12-17
12-17 12-17
Aluminum,
Steel
Brass, etc.
9-11 12-17
9-11 12-17
9-11 12-17
9-11 12-17
Aluminum,
Steel
Brass, etc.
- -
Aluminum,
Steel
Brass, etc.
- 12-17
33
Shell/
Ceramic Glass
Stone
- - -
- - -
- - -
- - -
- - -
- - -
Shell/
Ceramic Glass
Stone
- - -
- - -
- - -
- - -
Shell/
Stone Ceramic Glass
25-35 25-35 25-35
Shell/
Ceramic Glass
Stone
- - -