Unfolding The Cot With A Patient; Figure 25 - Using Two Operators; Figure 26 - Using Two Operators And Two Helpers - Ferno 28-Z PROFlexx User Manual

Using the Cot
6.3 Unfolding the Cot
With a Patient
Raising the cot from the folded to the unfolded position
requires a minimum of two trained operators (Figure
25). If additional help is needed, direct the helpers to
use the telescoping side lift handles (Figure 26).
To raise the cot:
1. Both Operators: Stand at opposite ends of the
cot, facing each other.
The foot-end operator grasps the cot main frame.
The head-end operator grasps the loading-wheel
crosstube.
° Grasp the loading-wheel crosstube, not the
backrest frame or the conversion handle. The
backrest frame and conversion handle are not
designed to be used to lift the cot.
2. Both Operators: Lift the cot until the
undercarriage unfolds completely and locks in
place (Figure 25).
To ensure that the safety lock is fully engaged,
you must lift the cot until all wheels are off the
ground, allowing the lock to fully engage if it has
not already done so.
Note: Do not squeeze the undercarriage control
handle. This will prevent the lock from engaging
(see Undercarriage Control Handle, page 14).
3. When you are sure the lock is engaged, set the
cot down.
20
Model 28-Z PROFlexx

Figure 25 - Using Two Operators

Figure 26 - Using Two Operators and Helpers
Important
Lift the cot until all four wheels are off the
ground. This allows the locking mechanism to
fully engage if it has not already done so.
Important
When lifting the cot, the head-end operator
grasps the loading-wheel crosstube. Do not
grasp the backrest frame to lift the cot. The
backrest frame is not designed for lifting.
© Ferno-Washington, Inc. 234-3356-00 August 2006
Chair Cot
®