Backrest; Wheel Locks; Figure 17 - Using The Backrest Control Handle; Figure 18 - Engaging/Disengaging The Wheel Lock - Ferno 28-Z PROFlexx User Manual

Using the Features
5.4 Backrest Control Handle
• Location: Beneath the backrest.
• Purpose: Adjusts between 0° and 85° for patient
comfort or medical necessity.
•
Before Use:
° Be prepared to support the backrest and patient
weight while adjusting the backrest.
• Use: To adjust, press the red control hand toward
the backrest (Figure 17), raise or lower the
backrest to the desired position, and release the
handle to lock in place.
° The gas spring is under pressure to ease raising
and lowering. Control the upward movement of
the backrest so it does not move too forcefully.
Note: When the operator cannot stand behind the
backrest it can be adjusted from the side but the
operator must be able to support the weight
throughout the adjustment.

5.5 Wheel Locks

• Location: Both foot-end wheels.
• Purpose: Locks stop wheels from rotating and
swiveling to help keep the cot stationary during
patient transfer and certain medical procedures.
° Wheel locks are not designed for use as brakes.
Remain with the cot and keep control of it at all
times. Do not leave the cot or patient unattended.
Use: To engage, press down on the free end of
•
the lock lever with your toe (Figure 18). To
disengage, press down on the opposite end of the
lock lever with your toe (Figure 18).
16
Model 28-Z PROFlexx
Figure 17 - Using the Backrest Control
Handle
Disengage
Figure 18 - Engaging and Disengaging the
Wheel Lock
© Ferno-Washington, Inc. 234-3356-00 August 2006
Chair Cot
®
Engage