Troubleshooting - Gaggia 10002008 Operation And Maintenance Manual

P
ROBLEMS
The machine does not turn on.
Hot water or steam is not
dispensed.
Coffee has little crema.
The Brew Group does not come
out.
Coffee is not brewed.
Coffee is brewed slowly.
Coffee leaks out of the dispensing
head.
The machine grinds the coffee, but
is not brewed in the cup.
Please contact the service centre for any problems not covered in the above table or when the suggested
solutions do not solve the problem.
C
AUSES
The machine is not connected to the power
source.
The plug has not been plugged into the
back of the machine.
The hole of the steam spout is clogged.
The coffee blend is unsuitable or coffee is
not freshly roasted.
Turn the E-Plus System knob leftwards.
The Brew Group is out of place.
Coffee grounds drawer is inserted.
Water tank is empty.
Brew Group is dirty.
Coffee is too fi ne.
Brew Group dirty.
Dispensing head is clogged.
The "Opti-dose" adjustment is not optimal.

TROUBLESHOOTING

S
OLUTIONS
Connect the machine to the power
source.
Insert the plug into the machine's
power socket.
Clean the hole of the steam spout
using a pin.
Change coffee blend.
Turn the E-Plus System knob
rightwards.
Turn the machine on. Close the
service door. The Brew Group is
automatically placed in the correct
position.
Remove the grounds drawer fi rst, then
the Brew Group.
Fill the water tank and prime the
circuit again.
Clean the Brew Group.
Change coffee blend.
Decrease the dose.
Clean the Brew Group.
Clean the dispensing holes with a soft
cloth.
Set the "Opti-dose" adjustment (see
page 8).
33