Master/Slave Connectivity; Mounting; Orientation; Rigging - Chauvet Ovation E-910FC User Manual

S
ETUP

Master/Slave Connectivity

The Master/Slave mode allows an Ovation E-910FC (the master) to control one or more Ovation E-910FC
products (the slaves) without a DMX controller. One Ovation E-910FC becomes the master when running
an auto or custom program, or in Static mode.
Each slave's control panel must be configured to operate in Slave mode. During Master/Slave operation,
the slaves will operate in unison with the master.
DO NOT connect a DMX controller to products operating in Master/Slave mode. The
DMX controller signals may interfere with the signals from the master.
• The Operation
configure the master and slaves.
• For more information about DMX standards or the DMX cables needed to link this
product to a DMX controller, download the DMX primer from the Chauvet website:
www.chauvetprofessional.com

Mounting

Before mounting the product, read and follow the safety recommendations indicated in the
For CHAUVET Professional line of mounting clamps, go to: http://trusst.com/products/.

Orientation

Always mount this product in a safe position, ensuring that there is adequate room for ventilation,
configuration, and maintenance.

Rigging

Chauvet recommends using the following general guidelines when mounting this product:
• Before deciding on a location for the product, make sure there is easy access to the product for
maintenance and programming purposes.
• Make sure that the structure onto which the product will be mounted can support the product's
weight. See the Technical Specifications
• When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
• When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
• When power linking multiple products, mount the products close enough for power-linking cables to reach.
• The bracket adjustment knobs allow for directional adjustment when aiming the product to the desired
angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the knobs.

Procedure

The Ovation E-910FC comes with a double-bracketed yoke that can be used as a floor stand or to which
mounting clamps can be attached for hanging. Mounting clamps must be purchased separately. Ensure that the
clamps can support the weight of this product. Use at least one mounting point per product where necessary.
Mounting Diagram
Ovation E-910FC User Manual Rev. 11
section of this manual provides detailed instructions on how to
.
for weight information.
Mounting clamp
Mounting bracket
Safety cable
Bracket adjustment hand shank
Safety
Alternate Short Mounting
Page 7 of 21
Notes.