Fcc Information - Welch Allyn HR100 Directions For Use Manual

Directions for Use

FCC information

This device contains FCC ID: ED9LMX9820ASM.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and
radiates radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communication. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING For patients with a pacemaker, maintain a minimum of 6 inches
between the recorder and pacemaker. Turn the recorder off immediately and
provide appropriate patient care if you suspect the recorder affected the
pacemaker. The Health Industry Manufacturers Association recommends a
minimum 6-inch distance between a wireless radio and a pacemaker, which is
consistent with the recommendations of Wireless Technology Research. The
wireless radio is active for the first 15 minutes of the procedure only.
25