Grounding The Chassis - Avaya Virtual Services Platform 9000 Series Installation Manual

3. Remove the two upper screws from the power cable receptacle panel on the rear
4. Position the power cable bracket notches over the chassis positioning studs and

Grounding the chassis

Ground the chassis before you install power supplies or connect power and network cables to
the system.
Before you begin
• Ensure you have a two-hole cable lug that fits over the grounding studs.
• Ensure you have a nut and a locking washer for the grounding stud.
• Ensure you have a 6-AWG green and yellow grounding wire long enough to connect to
the ground point.
• Ensure you have a 1/4 inch (6 mm) socket or nut driver.
Installation — Chassis
of the chassis.
reuse the two screws you removed to fasten the power cable bracket as shown. Do
not attach any cables until after the bracket installation.
Virtual Services Platform 9012 chassis installation
November 2013 95