Grounding The Chassis - Avaya Virtual Services Platform 9000 Series Installation Manual

Grounding the chassis

Ground the chassis before you install power supplies or connect power and network cables to
the system.
Before you begin
• Ensure you have a two-hole cable lug that fits over the grounding studs.
• Ensure you have a nut and a locking washer for the grounding stud.
• Ensure you have a 6-AWG green and yellow ground wire long enough to connect to the
ground point.
• Ensure you have a 1/4 inch (6 mm) socket or nut driver.
Procedure
1. Crimp the two hole lug onto the ground wire.
2. Attach the chassis ground cable to the grounding studs on the chassis. As shown
Installation — Chassis
in the following figure, the grounding studs are located on the bottom right of the
chassis rear.
Virtual Services Platform 9010 chassis installation
November 2013 57