Hobby OPTIMA ONTOUR EDITION 2019 Manual page 138

2
1
FI switch and test button
Residual current device
The standard version of your vehicle is equipped with a residual
current device that will interrupt the electric circuit in case of
a possible residual current. Should there be a malfunction, the
passenger circuit breaker opens the entire 230 V circuit.
Repairs must not be carried out on the residual current
device.
A residual current device does not guarantee any protection
against the danger from an electric shock.
It does not protect against possible electrical accidents.
The tripping time for the residual current device (RCD)
with a residual current of 30 mA is less than 0.1 seconds.
After putting the electric system into operation, the function of the
residual current device must be checked. After voltage has been
j
applied to the switch and it is on (set to I-ON) it must set off
when you press the test button
k
p.136 jumps down; after it has successfully
The rocker switch
been checked it must be switched back up to the "On" setting.
This check should be carried out at least once a month to ensure
that the residual current device functions perfectly in case there
should be a fault in the current.
When the residual current device has been set off (even
when testing) the customised settings in all mains-operated
devices are lost and the default settings made by the ma-
nufacturer will apply again.
f the automatic circuit breaker has gone off (other than if you
have switched it) you must wait a short while before switching
it on again.
- If the automatic circuit breaker remains active, there was only
an overload.
7. Electrical Installations
k
.
137