Hobby OPTIMA ONTOUR EDITION 2019 Manual page 176

As an optional extra, the vehicle can be fitted with the Combi E
*
heating system , which has additional heating rods for electric
operation.
Place of installation:
- side seat in the seating arrangement, external storage
locker or under the bed.
Initial operation
• Several air vents have been built into the mobile home.
Pipes transport the hot air to the air vents. Set the air
vents so that the hot air can escape to where it is re quired.
• Check that the chimney is clear. Remove any covers.
• Open the gas bottle and gas shutoff valve on the gas pipe.
• Only operate the device if it is in perfect technical condi-
tion.
• Always have malfunctions repaired immediately. Only
repair malfunctions yourself if such malfunctions are de-
scribed in the troubleshooting instructions in this manual.
• Do not carry out any repairs on or make any changes to
the device.
• Only have a defect device repaired by the manufacturer
or their service department.
If the system's power supply is interrupted, the time must
be reset.
Use the panel by the entrance to operate the basic functions
of the Combi heating system (see Chapter 7).
The change to the iNet-ready version was carried out duri-
ng the current season. Depending on when the trailer was
manufactured, iNet-ready functions are available, whereby
the Truma CP plus control panel functions as an interface for
operating connected devices via the Truma App and iNet Box.
10. Built-in devices 175