Wolfman B-Base SB-5 2020 Mounting Instructions

Wolfman B-Base SB-5 2020 Mounting Instructions

Advertisement

2020 B-Base SB-5 Mounting Instructions
****Please read and understand these instructions before touching your bike, rack or wrench. ****
Complete UnRack /B-Base Kit.
Thank You for your purchase.
The B-Base Parts FIG1
Center 2" D-Rings (6)
1" D-Rings (For mounting Bottle Holster)
Rear Mounting Strap
Front Mounting Straps
Center Mounting Straps
Rolie Bag Slots (4per leg)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B-Base SB-5 2020 and is the answer not in the manual?

Questions and answers

Summary of Contents for Wolfman B-Base SB-5 2020

  • Page 1 2020 B-Base SB-5 Mounting Instructions ****Please read and understand these instructions before touching your bike, rack or wrench. **** Complete UnRack /B-Base Kit. Thank You for your purchase. The B-Base Parts FIG1 Center 2” D-Rings (6) 1” D-Rings (For mounting Bottle Holster) Rear Mounting Strap Front Mounting Straps Center Mounting Straps...
  • Page 2 Installing the B-Base. Depending on Make and Model of Motorcycle you have, A Kiowa Heat Shield (HS402) is a MUST. As Wolfman Does not Warranty Heat Damage. A- Mounting Rear Strap 1. Place B-Base across the passenger seat or rear section of your seat. FIG2...
  • Page 3 C-Prepare the Rolie Bags. There are two methods to prepare the Rolie bags. 1-Thread the 1” Mounting straps through the slot under the Buckles on the Top/Front of t the Rolie Bag.FIG5 This is the most universal method. Use this method to attach a Rolie Bag to the Center 2” D-Rings FIG1 FIG5 FIG6 2-BEST METHOD- Thread webbing through the top and bottom slots on the back/bottom patch.
  • Page 4 4. Attach the 2” Wide Center Strap across the Center outside of the Rolie Bag. (On the 303 Rolies, that have the 2” D-Ring at the bottom Remove the 2” Side release buckle, Thread the Long Bottom strap through the 2” D- Ring under the Bunji, re-thread the 2”...
  • Page 5 **A few reminders: ***Re-check and Tighten All Webbing Securely. ***The Correctly Mounted Kit should look like the Complete Un-Rack B-Base Kit on Page 1. ***When Using 303 Rolies, simply Remove liner to Un-Load. To Load, Fill Liner about halfway before inserting into outer bag, then fill the rest of the way.

Table of Contents