Wolfman Rolie Small Basic Mounting Manuallines

Bag for ktm exc/xcw

Wolfman Basic mounting guidelines for the Small and Medium Rolie Bag to

For KTM EXC/XCW Models

the rear of a seat.

Rolie Bag mounted correctly to rear of seat of a KTM 530 XCW. Fig. 1

The Small and Medium kit contains:

1-Bag,

2-Seat Straps with loop sewn in center and 4 flappy strap keepers attached

1-Protective Pad (attached to back of bag). Fig 2

****Please read and understand these instructions before touching your bike, rack or wrench.****

Mounting.

1. Remove Seat. Consult your owners/shop manual for this procedure.

2. Clean Rear Fender section. Make sure it is free and clear of Dirt and oil.

3. Peel and stick one of the Hook strips to the rear fender below the molding mark. Fig. 3. Press firmly

for best results. Trim if needed.

Table of Contents

Do you have a question about the Rolie Small and is the answer not in the manual?

Page 1 Wolfman Basic mounting guidelines for the Small and Medium Rolie Bag to For KTM EXC/XCW Models the rear of a seat. Rolie Bag mounted correctly to rear of seat of a KTM 530 XCW. Fig. 1 The Small and Medium kit contains:...
Page 2 Fig. 3 4. Place loop of seat strap on the Hook. Fig. 4 Fig.4 5. Replace seat. 6. The rear Strap goes the rear fender between the Underside of the rear fender and "KTM Description- Number Plate Carrier." You will need to losen the two 8mm bolts to thread the webbing through. Fig. 5 Fig.5 7.
Page 3 For Best Results use the Ratchet Method of Tightening webbing. Most of us just grab and pull webbing to tighten it. Well there is an easier way. 1. Pull Up on the loose end of webbing lifting the buckle while pushing on the webbing before the buckle. Fig.1 Fig.1 Fig.2...

Rolie medium