Wolfman EX505 Mounting Instructions

Wolfman EX505 Mounting Instructions

Expedition dry saddle bags

Advertisement

Mounting instructions for the Expedition Dry Saddle Bags EX505/6 with our A146 Universal
*READ THROUGHLY BEFORE ATTACHING BAGS TO RACKS*
*For best results take a test ride before putting your Expedition Dry Saddle Bags to use*
*Helpful hint: Before you begin stuff each bag with a sleeping bag or quilt to give it body*
FIG1 Right side
*Please note the various parts of the saddlebag. Since the left and right bags are identical only one is shown.
FIG3
Saddle Bag Straps. Patents Pending.
Thank you for purchasing the Expedition Dry Saddle Bags
*The mounting is the same for both left and right bags*
Bag orientation
Seat straps
2" D-rings (2)
1"Center buckle (1 on each front patch)
1" Side mounting straps (2 on each side)
Saddle Bag Strap with wolf logo (2 on each side)
FIG2 Left side
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EX505 and is the answer not in the manual?

Questions and answers

Summary of Contents for Wolfman EX505

  • Page 1 Mounting instructions for the Expedition Dry Saddle Bags EX505/6 with our A146 Universal Saddle Bag Straps. Patents Pending. Thank you for purchasing the Expedition Dry Saddle Bags *READ THROUGHLY BEFORE ATTACHING BAGS TO RACKS* *For best results take a test ride before putting your Expedition Dry Saddle Bags to use*...
  • Page 2 ATTACHING EXPEDITION DRY SADDLE BAGS TO VIRTUALLY ANY MOTORCYCLE SIDE RACK 1- Unclip the 1”center buckles on the upper and lower mounting patches and loosen the 1”side mounting straps. FIG4 1” Center buckle 2- Place bags over the seat and/or rear rack. Depending on the width of your motorcycle, you may need to adjust the height of each bag.
  • Page 3 FIG6 FIG7 5- Tighten the 1”mounting strap which will tighten the saddle bag strap and the ¾” slide is captured, as shown in FIG8 6- Repeat steps 6-8 for all Saddle Bag Straps (4 per bag). 7- Pictured are correctly mounted top and bottom Saddle Bag Straps. FIG9...
  • Page 4 FIG9 8- Re-clip the 1” center buckles on each front top and bottom patch. FIG10 9- Tighten the 1”side mounting straps to secure and compress the bag to the rack, pull away from the 1”center buckles in the direction of the Arrows. FIG11 FIG10 FIG11...
  • Page 5 10- Thread excess webbing through plastic loop and strap keeper, repeat this for all excess webbing. FIG12 Plastic loop and strap keeper (4 per bag). 11- Tighten the 2” wide seat straps by pulling the webbing away from the 2” buckles. FIG13 Always use the seat straps.
  • Page 6 16- Use the top straps as handles and remove the bags away from the side racks.FIG15 Note: All of the mounting straps on the Wolfman Expedition Dry Saddle Bags are removable and replaceable. Extra mounting kits can be purchased from us.

This manual is also suitable for:

Ex506

Table of Contents