Table of Contents
Advertisement
3.3.2
Connecting the supply and wastewater pipes
Connecting the wastewater pipes
Connecting the supply lines
Flushing station with Viega Hygiene+ technology
▶
Mark the positions for the dowel holes.
▶
Drill the holes and insert the dowels.
▶
Put the basic holder system on the dowels and hand-tighten the
screws.
▶
Align the basic holder system once more using a spirit level, and
tighten the screws.
Further see
Ä Chapter 3.3.2 „Connecting the supply and wastewater
pipes" on page 25.
Installation variants
If you intend to insert the flushing station in a ring
n
system installation, you need to mount a T-piece in the
pipe. Next, the flushing station must be connected via
a single connection pipeline which should be as short
as possible.
If you intend to insert the flushing station in a series
n
pipeline installation, the flushing station must be
mounted and connected as a last consumer.
1
When connecting the odour trap to the disposal system,
observe the general rules of engineering, see
tions from section: Connecting the supply and wastewater
pipes" on page 7.
No additional odour trap is required.
2
▶
Connect the wastewater pipe (2).
The general rules of engineering must be observed for the
planning, execution, operation and maintenance of pot‐
able water installations, see
Connecting the supply and wastewater pipes" on page 7.
Handling
Ä „Regula‐
Ä „Regulations from section:
25
Advertisement
Table of Contents
