Alkaline Battery Installation - Sanyo CDP-455 Instruction Manual

ii
ALKALINE BAITERY
(not supplied)
INSTALLATION
Insert two "AA batteries (not supplied)
into the battery compartment on the bot-
tom of the unit. Be sure to observe the
proper polarity (the "+" and "-" signs, as
indicated inside the battery compartment).
f
Notes on Alkaline Batteries
When replacing the alkaline batteries,
use two new batteries of the same type.
Do not mix a used battery with a new
one or mix different types of batteries.
" When inserting the batteries, mistak-
enly inserting even one with improper
polarity will cause leakage.
Never charge, heat, disassemble, or
throw batteries into a fire.
When the batteries have become dis-
charged, they must be disposed of in a
safe manner that complies with all ap-
plicable laws.
Battery Recharging or Replacement
[f the rechargeable nickel-cadmium
battery or alkaline batteries are weak
and discharged,
"~" flashes in the
display, then the power automatically turns
off. If this occurs, recharge the recharge-
able nickel-cadmium battery or replace
the alkaline batteries before using the unit.
" This unit can be used if the recharge-
able nickel-cadmium battery or alkaline
batteries are removed, as long as the
supplied AC adaptor is connected.
When you are not going to use the
ur%t for one month or more, take the
rechargeable nickel-cadmium battery
of alkaline batteries out of the battery
compartment.
To remove the rechargeable nickel-
cadrmium battery or old batteries, press
down on one end of the battery so the
battery pops out from the compartment.
NOTE: If the operating buttons do not
function when pressed...
1.
2.
3.
Check whether the HOLD switch is on
or not.
Remove the batteries and/or discon-
nect the AC adaptor from the unit. Wait
a. few seconds, then reinstall the
batteries or reconnect the AC adaptor.
If the buttons still do not function, in-
sert new batteries or charge the
rechargeable nickel-cadmium battery.
-13-