Advertisement
PRECAUTIONS FOR HANDLING DISCS
n
With new discs
The symptoms described below sometimes
occur when new discs are used.
l
The disc is not played even when it is
loaded.
l
Operation changes to the next disc
before the first disc has a chance to be
played.
The same disc is played over and over
l
again.
The designated disc is not played.
l
These symptoms occur when there are
burrs on the center
hole or outside circum-
ference of the disc and, as a result, the disc
has not been loaded properly or the disc
catches on something inside the magazine.
In cases like these, remove the burrs using
a ball-point pen or similar implement, as
shown in the figure on the right.
When using 8 cm CDs, use a 8 cm CD
adapter which conforms to CD standards
and be sure to load the CDs in trays No. 1,
3, and 5 (gray trays). Loading CDs into
other trays will result in a malfunction.
Be sure to attach the disc properly to the
catches provided on the adapter. If the
disc is not attached correctly, it may come
free inside the magazine or play mecha-
nism,
rendering
the
unit
inoperable.
Under no circumstances must an empty
8 cm CD adapter be loaded inside the
magazine.
If this warning is not heeded,
the adapter will remain inside the mecha-
nism,
rendering
the
unit
inoperable.
WARNING
n
Although protective film is being marketed
a s C D a c c e s s o r i e s , u s e o f t h e s e p r o d u c t s
will result in malfunctions and should
absolutely
be
avoided.
/ c i r c u m f e r e n c e
Remove all plastic particles
of burr
from
surfaces of disc before loading
in
magazine.
8 cm CD Adapter
adapter
C D '
8 c m
Empty 8 cm CD adapter
INSTALLATION PARTS
Bracket (R)
Bracket (B)
Bracket (L)
x 2
Tapping screw
pin
D I N 8
( M 5 x 1 . 2 )
x 4
ID (Identity) SWITCH FOR CD CHANGER
ID switch
By using the separately sold Divider unit (FTP-CHlS), an additional CD changer
(FXD-Cl00 or FXD-C200) can be installed. When an additional CD changer has
been attached in this fashion, the ID switch is used to indicate the number of each
respective
changer
unit.
When changer is used independently
l
* The ID switch is initially set to "1" when shipped.
l
When changer is used as additional changer unit
1st
unit
* Use a ballpoint pen or similar fine-tipped implement to change the orientation of
the switch.
Hexagonal bolt
Hexagonal bolt
Nut
with washer
(M5 x 8)
x 4
x 4
x 4
Seal
Double
sided tape
2nd unit (additional changer unit)
Advertisement
