Battery Installation - Sanyo CDP-865CR Instruction Manual

Hide thumbs Also See for CDP-865CR:
Table of Contents

Advertisement

- Only use the NBP-50A
rechargeable
battery. Under normal usage conditions,
this
battery
can
be
recharged
approximately
500 times.
If a different type of rechargeable battery
is installed, it cannot be recharged.
- If the operating time decreases drastically
even when the rechargeable
battery is
properly
recharged,
purchase
a new
NBP-50A.
- Do not charge continuously for 24 hours
or more.
- Do not short-circuit the+ and – terminals
of the battery,
- Do not put batteries in water or fire.
- Do not disassemble
batteries.
-
Battery recharging
or replacement
If the rechargeable
battery
or alkaline
batteries are weak and discharged, " ~"
blinks
on the display,
then the power
automatically
turns
off. If this occurs,
recharge
the rechargeable
battery
or
replace the alkaline batteries.
- When you are not going to use the unit
for one
month
or more,
take
the
rechargeable baftety or alkaline batteries
out of the battery compartment.
ALKALINE
BATTERY INSTALLATION
Insert two "AA" batteries (not supplied). Be
sure to observe the proper polarity.
Notea on alkaline batteries
When replacing the batteries,
use two
new batteries of the same type. Do not
mix a used battery with a new one or mix
different types of batteries.
Never charge,
heat, disassemble,
or
throw batteries into a fire.
When
the
batteries
have
become
discharged, they must be disposed of in
a safe manner
that complies
with all
applicable
laws.
7

Advertisement

Table of Contents
loading

Table of Contents