The incoming connection, or serial server mode, takes precedence. An outbound, or client,
connection will be interrupted if a connection is made on the incoming, or server, listening port.
NOTE:
Instructions in this section assume that you have established cellular service and the SIM card
has been installed as described in
6.4.5.1 Configure CELL200 series
To set up the CELL200 series in serial server mode:
1. Connect a USB cable between your module and computer.
2. Connect the Cellular antenna.
3. Connect the Diversity antenna, if used. (Not required. See
4. Open a web browser and go to: www.cell.linktodevice.eu/.
TIP:
If your computer does not respond to the DNS server correctly, browse to 192.168.86.1.
5. On the Settings tab, enter the APN provided by your cellular provider.
6. On the General tab, set Mode to Serial Server/Client.
QuickStart (integrated mode)
CELL200-Series 4G LTE Cellular Module
(p. 8).
Antenna connections
(p. 29).)
50