Table of Contents
Advertisement
Image 11-17: Mount light source cover
Close the cover as follow:
1.
Gently move the bottom side of the cover towards the projector
2.
Push both lock to each other and push at the same time the cover against the projector frame.
3.
Release both locks so that they lock in their receivers.
2.
Secure the cover by fasting both captive screws.
Image 11-18: Secure light source cover
11.9 Installation of the rear cover
Required tools
Flat screwdriver
How to install
1.
Install the rear cover of the projector doing the following:
1.
Bring the rear cover towards its final position.
2.
Gently push the locking studs into the receivers (1).
Note: Gently install the back cover, ensure the UPS cable is not damaged by guiding it into the
foreseen cavity in the cover.
Removal and installation of the projector covers
R5906897 /02
Prometheus III
145
Advertisement
Table of Contents
