Table of Contents
Advertisement
Image 5-13
5.
Slide both top plates as indicated into the grooves. Slide until you reach the position plate and the hole
matches the hole in the brackets. Use one screw (M3) on each side of the top plates and tighten them fully
until the brackets are pushed strongly against the ribs in the cover and middle bracket.
Tip: Put in place the screws, without tightening them, before slide the top plates. It is more easy to
positioning the screws when the top plates are not in place.
Image 5-14
6.
Hook the middle bracket support into the middle bracket.
Turn in the fixation screw (M4).
Physical installation stand alone cooler
R5906897 /02
Prometheus III
49
Advertisement
Table of Contents
