Introduction; Description Of The Co2 Jet And Its Usage; Necessary Accessories - Magicfx CO2 Jet User Manual

Hide thumbs Also See for CO2 Jet:

Table of Contents

5. INTRODUCTION

5.1

The CO2 Jet is designed to place on a stage and produce white cryogenic smoke plumes of CO2 gas

upwards. This gives a special effect on stage. As soon as the liquid CO2 from the CO2 bottle comes

(via the high pressure hose) out of the CO2 Jet, the liquid turns into gas which give a spectacular

white smoke plume. This effect will also produce a strong sizzling noise. The output of the CO2 Jet is

approximately 8m. This depends on the humidity. At a high

humidity the output will be higher and at a low humidity the output will be less.

The CO 2 jet needs to be connected to a liquid carbon dioxide (CO2) cylinder with a dip tube.

The CO2 Jet is not suitable for gases other than described above.

Any other use than intended use described above, connect your supplier of

any responsibility

5.2

The following parts are required with the CO2 Jet:

MFX0308 – Shuko – neutrik

Table 5.1

Manual

powercon cable 1.5m

MFX1155 – HIGH PRESSURE HOSE

CYLINDER (with dip-pipe)

Version 1.0

Page 6

Table of Contents