Table of Contents
Advertisement
User Documentation MAGICFX® CO2 Jet
10. INSTALLING
Prepare the CO2 Jet for use as follows:
1.
2.
3.
Page 11
CAUTION:
This indicates that the equipment may be damaged if procedures are not
carried out in the proper manner.
DANGER WARNING:
The MAGICFX® CO2 Jet may only be installed by authorized adults.
Place the CO2 bottle on a flat and stable
surface and secure it by a certified gas
bottle bracket with chain to make sure the
CO2 bottle can't tip.
Appoint the opening of the CO2 bottle
away from the crowd. Place the CO2
bottle outside or in a special area which
is very well ventilated and where a CO2
detection system is installed.
Contact your CO2 gas supplier for further
instructions and safety guidelines.
Place the CO2 Jet on a flat and stable
surface of wood (like a stage).
Fasten them by 4 screws of minimum
5cm long.
Connect the CO2 high pressure hose
tightly to the CO2 Jet by using a wrench
(size 22).
Advertisement
Table of Contents
